AquaCraft Nitro Hammer GP Vee RTR

This is the Nitro Hammer RTR Radio Controlled Nitro Powered Deep Vee Boat
by Hobbico.

FEATURES: Virtually everything is installed or assembled.
Includes a boat stand and a video that shows how to break in and
maintain the included .15 Marine engine with recoil.
Fuelproof fiberglass hull and deck are prejoined, and factory-
finished.
Each color corresponds to a different radio frequency, and all
are protected by a tough Gel Coating.
AquaCraft engine is a true ABC engine, with dual bearings, and a
two needle carburetor. Glow plug, manifold, tuned pipe, and
engine break-in video included.
The receiver and servos for the AquaCraft 2-channel radio are pre-
installed. The radio is made by Futaba, the #1 name in R/C radios.
The radio has adjustable steering rates, trims, servo reversing,
a battery monitor, charge jack and a light and well balanced feel.

INCLUDES: Ready to Run Nitro Hammer GP Deep Vee boat, with radio, boat stand,
2-channel AM Pistol Style 75MHz radio, .15 Marine Engine w/ recoil
(HCAG1115), with header and tuned pipe, and engine break-in video.

REQUIRES: 20% Glow Fuel
Glow Starter
12 "AA" batteries for the radio.

SPECS: Length: 24" (610mm)
Beam: 8.75" (220mm)

COMMENTS: The stock number for the engine is HCAG1115.
The hull color of each boat is different depending on radio channel;
HCAB2662White HCAB2670 Yellow
HCAB2664 Blue HCAB2672 Gray
HCAB2668 Red HCAB2674 Orange

From the Research & Development Department.

What to use for hull repairs.
The Hobbico Nitro Hammer boat has a gel coat on the outside of the
hull. WE DO NOT RECOMMEND THE USE OF AUTOMOTIVE FIBERGLASS RESIN
TO DO ANY REPAIRS TO THE HULl. IT IS TOO STRONG TO USE AND COULD
RESULT IN A DAMAGED HULL. It was suggested to use Epoxy (GPMR6040)
mixed with micro balloons (TOPR1090). Mix together, apply to damaged
part of the hull, smooth out, let cure and wet sand if needed for a
good smooth solid repair.

AquaCraft